CodesBrandsGuidesTutorials
EN
EnglishEspañolDeutsch

P024F: Charge Air Cooler Bypass Position Sensor A Circuit High

The charge air cooler bypass is a flap or valve that routes compressed air around the charge air cooler, so the engine and exhaust warm up faster after a cold start; when warm it closes or opens partly to control intake air temperature. It is driven by an electric motor with a built-in position sensor or by a solenoid and vacuum can. Its position sensor is usually built into the actuator, with a 5 V reference and a ratiometric signal. P024F means the signal is above its upper limit – typically an open sensor ground or a signal shorted to voltage. Bypass control is then switched off and the flap stays in its rest position. No manufacturer document using this code was found – GM and Ford do not use the bypass codes; the description rests on CARB's component monitoring requirement and a Bosch patent on the bypass valve.

Medium severity. Can I keep driving?Drive without demanding power and go to a repair shop soon. If you see a lot of blue smoke or hear a metallic noise, shut off the engine.

Symptoms

  • Check engine light on
  • Depending on the rest position: longer warm-up or higher charge air temperature with slight loss of power
  • Often nothing noticeable while driving

Most likely causes

  • Sensor ground open
  • Signal shorted to 5 V or system voltage
  • Sensor faulty
  • Connector corroded

What to check, in order

Start with the simplest. You can tick off each step.

Good to know

  • Repair difficulty: medium
  • It affects emissions.

What each character of P024F means

  • P: Powertrain: engine and transmission
  • 0: Generic code: same on every make
  • 2: Fuel injection
  • 4F: Specific fault in that system

Frequently asked questions

Can I keep driving with code P024F?

Drive without demanding power and go to a repair shop soon. If you see a lot of blue smoke or hear a metallic noise, shut off the engine.

What causes code P024F?

The most common causes are: sensor ground open; signal shorted to 5 V or system voltage; sensor faulty.

Related codes

Sources

Values and procedures vary by manufacturer. If it affects brakes, steering, fuel or high voltage, see a professional. Updated: 2026-11-04. How we build these pages.