P052D: Cold Start A Camshaft Position Timing Over-Retarded Bank 2

Some engines shift the intake (A) camshaft right after a cold start so that more exhaust heat reaches the catalyst; CARB requires each commanded element of this cold-start strategy to be monitored under its own codes. Documented only by Ford (from 2008): during the first 60 s it checks the cam position for 5 s and sets a code above 11° deviation, plus a stuck-pin test (10° commanded, under 2° movement) and an averaged deviation index. Warning lamp after two trips; afterwards the normal cam codes take over. P052D means bank 2 of a V engine was too far retarded. Outside cold start, P0022 applies.

Bank 2 is the side without cylinder 1, so it only exists on V or boxer engines.

Symptoms

• Check engine light on
• Usually no noticeable driving symptoms
• Possibly rattle or rough idle on cold start
• Higher cold-start emissions

Most likely causes

• Cam phaser sticking or lock pin not releasing (bank 2)
• Low oil level, wrong viscosity or sludged oil
• Oil control valve sticking or screen clogged
• Stretched timing chain

What to check, in order

Start with the simplest. You can tick off each step.

1. Check the oil level and condition before anything else
2. Use the scanner to command the movement and compare the actual position with the requested one.
3. Check the solenoid valve's connector
4. Compare commanded and actual angles in live data
5. Test the solenoid valve and its filter, if it has one
6. Check the engine timing if there is chain noise

Good to know

• Repair difficulty: medium
• It affects emissions.

What each character of P052D means

• P: Powertrain: engine and transmission
• 0: Generic code: same on every make
• 5: Speed and idle
• 2D: Specific fault in that system

Frequently asked questions

Can I keep driving with code P052D?

Drive little and gently. If you hear timing chain noise or the oil light comes on, shut off the engine.

What causes code P052D?

The most common causes are: cam phaser sticking or lock pin not releasing (bank 2); low oil level, wrong viscosity or sludged oil; oil control valve sticking or screen clogged.

Related codes

• P052BCold Start A Camshaft Position Timing Over-Retarded Bank 1
• P052CCold Start A Camshaft Position Timing Over-Advanced Bank 2
• P0022"A" Camshaft Position - Timing Over-Retarded (Bank 2)
• P0020"A" Camshaft Position Actuator Circuit (Bank 2)
• P054DCold Start B Camshaft Position Timing Over-Retarded Bank 2

Sources

• newtonnet.co.uk: fordobd2012
• fordservicecontent.com: OBD Operations Summary Gasoline 2020 2023
• law.cornell.edu: 13 CCR 1968.2

Values and procedures vary by manufacturer. If it affects brakes, steering, fuel or high voltage, see a professional. Updated: 2026-11-04. How we build these pages.