P0DEE: Pedestrian Alert Control Module Circuit Low

P0DEE is set when the hard-wired circuit to the pedestrian alert control module sits below its expected voltage, typically from a short to ground. No manufacturer documents P0DEE publicly, so the exact signal behind it, whether supply, wake-up or a command line, is not known in detail. A ground short often blows a fuse or makes the driving module disconnect the line, and the alert then falls silent, even though FMVSS 141 expects a sound from standstill with propulsion on, in reverse and up to around 30 km/h; EU vehicles must carry such a system as well. Look along the whole harness run, which can be long: on Ford's 2020-21 Escape Hybrid the module sits in the right rear quarter. Open circuit is P0DED, short to voltage P0DEF.

Medium severity. Can I keep driving?It depends on the symptoms. If the car is running normally you can go to a repair shop; if it goes into limp mode, drive as little as possible.

Symptoms

Pedestrian warning sound missing
Warning message in the instrument cluster
Fuse for the alert module may be blown

Most likely causes

Chafed or crushed wire shorting to ground
Water ingress in a connector near bumper or wheel arch
Internal short in the alert module

What to check, in order

Start with the simplest. You can tick off each step.

Check the battery and grounds
With the connector unplugged, check whether the signal wire is making contact with ground.
Clear the code and see if it returns
If it is a reference voltage code, disconnect sensors one at a time and see if the voltage recovers
Check whether a software update is available
Do not replace the control module without a full diagnosis

Good to know

Repair difficulty: medium

What each character of P0DEE means

P: Powertrain: engine and transmission
0: Generic code: same on every make
D: Subsystem depends on the code range
EE: Specific fault in that system

Frequently asked questions

Can I keep driving with code P0DEE?

It depends on the symptoms. If the car is running normally you can go to a repair shop; if it goes into limp mode, drive as little as possible.

What causes code P0DEE?

The most common causes are: chafed or crushed wire shorting to ground; water ingress in a connector near bumper or wheel arch; internal short in the alert module.

Related codes

Sources

Values and procedures vary by manufacturer. If it affects brakes, steering, fuel or high voltage, see a professional. Updated: 2026-11-04. How we build these pages.