U0347: Software Incompatibility With Hybrid/EV Battery Interface Control Module N

A module reports a software version mismatch with hybrid/EV battery interface module N — typically after replacing one of the modules without programming the new unit to match the rest of the network.

High severity. Can I keep driving?If the car still runs, drive as little as possible and go to a specialized repair shop. Do not touch the orange cables: they carry high voltage.

Symptoms

Multiple warning lights may illuminate
Affected modules may go into limp mode or shut down
Specific functions inoperative depending on module
Diagnostic tools may show communication faults

Most likely causes

Module replaced without programming
Wrong part number for the vehicle
Gateway module routing CAN messages incorrectly

What to check, in order

Start with the simplest. You can tick off each step.

Read the codes with a hybrid-compatible scanner and write down the freeze frame data
Make sure the battery cooling air intake is clean
Check the 12 V auxiliary battery, which can also trigger warnings
Leave any high-voltage measurements to a specialized repair shop

Good to know

Repair difficulty: medium
It can trigger limp mode.

What each character of U0347 means

U: Communication network
0: Generic code: same on every make
3: Subsystem depends on the code range
47: Specific fault in that system

Frequently asked questions

Can I keep driving with code U0347?

If the car still runs, drive as little as possible and go to a specialized repair shop. Do not touch the orange cables: they carry high voltage.

What causes code U0347?

The most common causes are: module replaced without programming; wrong part number for the vehicle; gateway module routing CAN messages incorrectly.

Related codes

Sources

Values and procedures vary by manufacturer. If it affects brakes, steering, fuel or high voltage, see a professional. Updated: 2026-11-04. How we build these pages.