P0B1B: Hybrid/EV Battery Pack Voltage Sense C Circuit Low

P0B1B sets when pack voltage measurement C delivers a reading below its plausible lower limit. Typical electrical causes are a sense lead shorted to ground, an open fuse or resistor in the sense path, or a defective controller input. No manufacturer documents this code publicly. GM applies the same idea to channel A, where P0ABC sets below 24 V pack-side voltage for 1.6 s in a 2 s window, Type A. CARB calls for out-of-range monitoring of battery voltage sensors. The high counterpart is P0B1C and the plausibility code P0B1A. A pack voltage reading that is too low can prevent precharge and contactor closing, so the vehicle may not become ready to drive.

High severity. Can I keep driving?If the car still runs, drive as little as possible and go to a specialized repair shop. Do not touch the orange cables: they carry high voltage.

Symptoms

Vehicle may not reach Ready or may shut down the high-voltage system
MIL and hybrid/EV system warning on
Battery power limited, reduced electric drive or assist

Most likely causes

Sense lead of channel C shorted to ground
Fuse or resistor in the sense path open
Measurement input of the battery controller defective

What to check, in order

Start with the simplest. You can tick off each step.

Read the codes with a hybrid-compatible scanner and write down the freeze frame data
With the connector unplugged, check whether the signal wire is making contact with ground.
Make sure the battery cooling air intake is clean
Check the 12 V auxiliary battery, which can also trigger warnings
Leave any high-voltage measurements to a specialized repair shop

Good to know

It can trigger limp mode.
It affects emissions.

What each character of P0B1B means

P: Powertrain: engine and transmission
0: Generic code: same on every make
B: Subsystem depends on the code range
1B: Specific fault in that system

Frequently asked questions

Can I keep driving with code P0B1B?

If the car still runs, drive as little as possible and go to a specialized repair shop. Do not touch the orange cables: they carry high voltage.

What causes code P0B1B?

The most common causes are: sense lead of channel C shorted to ground; fuse or resistor in the sense path open; measurement input of the battery controller defective.

Related codes

Sources

Values and procedures vary by manufacturer. If it affects brakes, steering, fuel or high voltage, see a professional. Updated: 2026-11-04. How we build these pages.